Savage Hydraulic Presses - Die / Mold Spotting Presses

Request Information

Unit of Measure

Items	90º - MSP 90º Mold Spotting Press	180º - MSP 180º Die Spotting Press	DSP - 100T Die Spotting Press
Description	N/A Unique four corner support design ties top and base into one rigid assembly. This design eliminates guide rod stress due to overhung loads imparted by heavy dies during the swing cycle and appreciably increases the accuracy of mold/die contact. Rack and pinion leveling or motion controls used on larger presses to maintain precision parallelism of the platens. Advantage of rear swing-out platen allows correction and grinding operations without interfering with similar operations performed simultaneously at the front of the press on the opposite die half.	N/A Savage's Mold Spotting presses are precision guided presses for the off line repair of dies and molds. Eliminates the bottleneck of tying-up your production press. Safety improvement over using cranes and chains with overhead lifting. Available in different types for different budgets. Models and sizes to fit your molds and dies.	N/A Savage die spotting presses are available in many configurations to meet your needs and desires. Illustrating both a basic no frills die spotting press and a die spotter with a shuttle bolster. Both presses have rack and pinion platen leveling or motion controlled leveling to insure parallel contact of dies and molds.
Capacity	N/A 100 tons (t)
Type	N/A	N/A	N/A With No Frills With Shuttle Bolster
Platen Angle	N/A 90 º	N/A 180 º	N/A
Platen Size	N/A	N/A	N/A 120 in x 96 in 168 in x 96 in
Daylight Opening	N/A	N/A	N/A 120 in
Features	N/A Four corner stabilization bars 90º rear swing-out platen Powered roll-out lower shuttle bolster Ram stroke control to ±.001 in allows ’kiss’ contact Digital ram position display Tonnage, bed size, daylight and stroke to your requirements Remote pressure and speed controls Extra long bronze guides Safety platen latches (std) Safety swing-in platen blocks Lower 45º tilt-up bolster (optional) Motion controlled leveling	N/A Time savings with a much more elegant solution over out-dated spotting methods Decouple from rams Frontal swing-out platen Model shown with frontal shuttle table and frontal 180º inversion of upper tool half Allows ergonomically comfortable work areas for repair and spotting Allows the booking open of injection molds and placing them face up, side by side for comparisons and repair Allows all tool correcting operations, bluing and grinding, to be performed safely outside of the press Precisely reassembles the tool for accurate, controllable spotting Auxiliary hydraulic functions such as core pulls with quick-connect couplers	N/A 100 Ton Press with 120 in x 96 in platens and 120 in daylight opening. Physical platen blocks allow tool maker to perform repairs in the press 100 Ton Die Casting Die Spotter with 168 in x 96 in opening between the uprights and a shuttle bolster. Allows lower die repairs outside of the press. Shown with 30 ton die casting die Down-acting clamp capacities to customer specifications Bed sizes and daylight openings to customer specifications T-slotted bolsters or T-slotted shuttle bolsters Shuttle table allows repair of die/mold safely outside of the press Shuttle table also allows easy crane loading of dies and molds Ram position controllers (RPC) for .001 in spotting accuracy Precision rack & gear leveling of platen Motion controlled electronic leveling available Bed sizes and daylight to suit application Lever or joystick operated hydraulics allow the operator more control over press motion Tryout presses available Compressed air quick disconnects for tools 120 volt duplex outlets for tool power takeoff